Vapor Barrier

Ask our experienced MH repair and renovation experts about your home repair needs!
Post Reply
Rosanne P

Vapor Barrier

Post by Rosanne P » Mon Nov 14, 2005 9:16 am

I'm in the process of buying a 2005 Double Wide in S. Florida. After having the unit inspected there was minor damage from Hurricane Wilma. Most of the damage came from the neighbors attached carport/screen room.

One of the issues the inspector had was concerning the vapor barrier which had several tears. They said it would be taped up with this special barrier tape and should be fine. As of this weekend I inspected the repairs and the tape is falling off.

I feel that this is important part of the house and should be intact. Is it too much to require that they replace this barrier?

Your comments are appreciated.

Mac

Re: Vapor Barrier

Post by Mac » Tue Nov 15, 2005 11:47 am

It is a big job to completely replace it, but there are good tapes to repair it. See the parts section of this website, or perhaps Mark will chime in on it. An alternative might be that they could replace sections, or overlap sections.

Mac

Re: Vapor Barrier

Post by Mac » Tue Nov 15, 2005 11:47 am

It is a big job to completely replace it, but there are good tapes to repair it. See the parts section of this website, or perhaps Mark will chime in on it. An alternative might be that they could replace sections, or overlap sections.

Eugene

Re: Vapor Barrier

Post by Eugene » Wed Nov 16, 2005 2:09 pm

Please don't replace it!!! you will end up with a mess.
A product called Flex-mend is really good.
Also, it is not a vapor barrier, it is bottom board. a vapor barrier lays on the ground. A bottom board protects the floor insulation.

Mitch Vierra

Re: Vapor Barrier

Post by Mitch Vierra » Wed Nov 30, 2005 6:55 am

another trick I have used is spray adhesive applied to a section of new material and sprayed to bottom material but use caution when doing this under home gloves and face protection a must

Margo

Re: Vapor Barrier

Post by Margo » Thu Dec 01, 2005 11:20 am

where do your find this flex mend to cover the 'vapor barrier' holes?
Margo

Red crane

Re: Vapor Barrier

Post by Red crane » Mon Dec 05, 2005 8:03 pm

I am a newbe and am awaiting for my lot to be prepared for our mobile home. I found something caled flex mend at http://www.mobilehomepartsstore.com/Mer ... y_Code=BBR
I dont know if this is what you are looking for, but maybe someone can verify it for us.

Red Crane

Post Reply

Who is online

Users browsing this forum: No registered users and 18 guests