Jalousie type windows in need of help

[Doug]

I have a travel trailer with Jalousie type windows in it and I want/need to replace the cranks on them. OK here is the problem there is a rod in the way! I need to move it so that I can replace those cranks. Does anybody know how to resolve this problem?

[David Oxhandler]

There were dozens of jal and awning window makers and each was a bit different If I'm picturing the right type window I remember the rod comes out when you open the window fully through a slot in the bottom of the window slide.

Take on of the cranks off and take a good look inside the crank for the pattern that locks it onto the opener..and see if you can find a brand name on the closer units, so you know what your shopping for. Each manufacturer made different cranks.

Click thru to the Mobile Home Parts Store they should have just what you need. If you dont find what you need click on the HELP link or phone the 800 number both at the top of their home page. Ask to speak to a customer service rep. Their guys are the court of last resort on parts and repair procedures.

In the event that you can't get them working you might want to consider new replacement window(s). Those crank out style windows were designed in the 1950's when gas was below 20 cents a gallon when energy efficiency was not a consideration. Even if you get them working smoothly, it is doubtful that they will ever seal closed tightly. You may be surprised how inexpensive Newer style windows the same size are and how much energy costs you will save over a very few years.

[catwhisperer]

Do they make windows to replace the jalousie windows in a 60's model trailer. Does anyone know how to stop this 60's model from having water and ice running down the inside of its exterior walls

[David Oxhandler]

It is not difficult to replace the old jal windows with modern single hung windows. You can find a number of window options at The Mobile Home Parts Store.

If the jalousie windoes are still operating removing and reinstalling them with new putty tape and a good bead of caulking at the top will often stop any leakage around the sides of the window frames.

"Using a professional to install mobile home replacement windows is great if you can afford it. However, if cost is an issue you can do the job yourself.

Mobile home replacement windows come in standard sizes. Measurements must be taken of the window hole. Ideally, the existing window is taken out and the hole is measured.

Sizing can be accomplished without removing the window by measuring the window only. Do not include the window trim or the outside window flange when measuring."
http://www.doityourself.com/stry/mobile ... nt-windows