The Manufactured Housing Forums

What is the proper way to seal nova deck in the wet areas? Ours has lino over the wet area but has been cut in places to install around pipes The lino is not glued down. Should it be? thanks Randy Also one bathroom has carpet. And some pipes come out of the wall .Does it need to be sealed at the floor plate in the wall? Also does the edge need to be sealed in the utility room and at the back door?

The floor deck in those wet areas should have been sealed at the factory. and yes, the lino should be sealed with a 4" band of adhesive at every opening, pipes, wires, heat ducts, etc.
The lino should run under the wall if not, it was most likely replaced and not done properly.