The Manufactured Housing Forums

My mom has a newer doublewide......through most of the home instead of mudding and taping the sheetrock they put strips where the sheets come together. What is the easiest way to remove and fix this, so that she will be able to paper or paint these walls?

Hi, first just making sure you have your terminology correct so were sure we are talking the same language. Most MH's do not have what is usually called sheetrock. Thats usually a term used in stick built homes and are actual gypsum quarter inch or larger sheetrock. What MH's have is call wallboard. Vinyl covering with a cardboard sandwich in between. However, some manufacturers do offer real sheetrock as an option.

The strips just pull off, but you will probably run into many staples that will have to be removed. The gaps can be filled with sheetrock mud of paintable silicone caulk. Care has to be taken to insure a smooth finish that will not show.

Since this wallboard it vinyl covered, you must clean and prime prior to painting or putting up wallpaper. Thats to insure a good finish for the paint to grab onto. If you do not do these steps, the paint will flake off in short order. Tom

This video may interest you.

Walls Video

Mark

What type of primer do you recommend?i am doing this also.Thanks!

Kilz or Zinsser are two of the popular primers. Tom

Thanks!

I have one section of the vinyl wallpaper that needs repaired but am unable to find the paper or the covered sheetrock do you have any places that I can find these items. My manufactured home was built in 95.

I own a 1998 Titan Hanufactured home.I would like to add a window in a bedroom.where there is not an existing window.Is this possible?Can a new cutout be made?Is there amuy wiring in the walls?Also my thereostat for my gas furnace is in the bedroom.Can that be moved to another place in the home.I like to open a window a bit during the winter and cannot do that with a thermostat in the room as it will throw on the furnace.Thanks!!!!!

I live in a double wide and am painting my walls this week. I was seriously considering taking the strips off and using the plaster stuff to fill in the gaps. how hard of a project is this? and is it necessary to prime before I paint? what do I need to clean the walls with?

TAKE STRIPS OFF THEN FILL GAPS WITH SHEETROCKMUD YOU CAN CLEAN WALLS WITH LIGHT DETERGENT AND WARM WATER AFTER MUD IS DRY SAND THEN PAINT DESIRED COLOR H&W PAINTING&REMODELING! OWNER&OPERATER